Performance monitoring
Perform a one-time round trip delay measurement for test
purposes
...................................................................................................................................................................................................................................
When to use
This procedure is used to perform a one-time round trip delay measurement to a
remote NE.
The Perform a one-time round trip delay measurement for test purposes
Note:
procedure is also applicable to X5IP.
Related information
The items below list other relevant information to this procedure:
•
"Ethernet service route round trip delay measurements" (p. 10-23)
Before you begin
The items below gives information on tasks to perform before beginning the procedure:
•
"Provisioning a virtual switch in spanning tree mode" (p. 8-105)
•
"Enable round trip delay measurements" (p. 10-69)
Procedure
...................................................................................................................................................................................................
Select the Ethernet Service Route in the Round Trip Delay Measurement window and
1
click
Test
Result:
...................................................................................................................................................................................................
Click
2
Result:
to finish this test. Are you sure you wish to trigger a one shot RTD measurement?
...................................................................................................................................................................................................
Click
3
Result:
window.
...................................................................................................................................................................................................
Click
4
E
N D
...................................................................................................................................................................................................
...................................................................................................................................................................................................................................
10-72
.
The RTD Test window appears.
.
Trigger
A message will appear on the screen with the lines: 15 seconds is needed
.
Yes
The RTD Value and Success Indication will be displayed in the RTD Test
Close
.
O F
S T E P S
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007