Performance monitoring
RTD PM counters, RDT/TCA support, and End-2-End Ethernet
PM - RTD
...................................................................................................................................................................................................................................
When to use
The following procedure is performed when you want to enable the RTD monitor
counters, to set the threshold values and the granularity of the monitored period.
Note:
procedure is also applicable to X5IP.
Related information
The items below list other relevant information to this procedure:
•
"Ethernet performance monitoring" (p. 10-12)
• Procedure to set the SDH TP Mode, for the required prior setting of the ports to be
monitored. Refer to
•
"Concepts" (p. 10-3)
Before you begin
The items below gives information on tasks to perform before beginning the procedure:
• Proper LAN card must be installed in TS2 in order to be able to make performance
LAN measurements.
• A prerequisite for this procedure is to set the virtual switch in spanning tree mode
"Provisioning a virtual switch in spanning tree mode" (p.
•
"Enable round trip delay measurements" (p. 10-69)
RTD counters
Follow this procedure in order to view the active measurement point settings of the
NE.
...................................................................................................................................................................................................
Select
1
Result:
Configuration mode.
...................................................................................................................................................................................................
Select
2
then click
Result:
...................................................................................................................................................................................................
Click
3
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
The RTD PM counters, RDT/TCA support, and End-2-End Ethernet PM - RTD
"Provision ports" (p.
→
Performance
PM TP Configuration
The Select Performance Monitoring Points window appears in the PM
Ethernet Service Route
Add
Ok
and
The
Ethernet Service Route
Add
.
Alcatel-Lucent - Proprietary
5-59).
.
for PM Point Type and enter the Service Route ID and
is enabled
See notice on first page
8-105).
10-67