Performance monitoring
Enable round trip delay measurements
...................................................................................................................................................................................................................................
When to use
Use this procedure to:
• create an Ethernet service route for round trip delay (RTD) measurements,
• provision the related parameters of the test frame that is required for RTD
measurements,
• start a cyclic RTD measurement.
Note:
Related information
The items below list other relevant information to this procedure:
•
"Ethernet service route round trip delay measurements" (p. 10-23)
Before you begin
The items below gives information on tasks to perform before beginning the procedure:
•
"Provisioning a virtual switch in spanning tree mode" (p. 8-105)
Procedure
...................................................................................................................................................................................................
Select
1
Result:
...................................................................................................................................................................................................
Select the desired LAN unit from the Physical Switch drop-down list box.
2
Result:
are currently provisioned for that unit.
...................................................................................................................................................................................................
Ethernet service route RTD measurements are only supported for virtual switches
3
operating in one of the following modes:
• STP virtual switch mode compliant with IEEE 802.1Q VLAN tagging mode with
oversubscription (that is, with encoding of the dropping precedence)
• STP virtual switch mode compliant with IEEE 802.1ad ("Provider bridge mode")
Select the desired virtual switch from the Virtual Switch List.
...................................................................................................................................................................................................
Click
4
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
The Enable round trip delay measurements procedure is also applicable to X5IP.
→
Provisioning
LAN Management
The Virtual Switch List window appears.
In the Virtual Switch List group box, the virtual switches are displayed that
RTD Measurement
.
Alcatel-Lucent - Proprietary
→
Virtual Switch
See notice on first page
.
10-69