Table of Contents
Advertisement
Important notes on this procedure
Cleaning requires the cleaning liquid and cleaning sticks included with the printer, so have these
items ready.
Before performing this operation, remove any media.
To prevent the heads from drying out, finish this procedure in 10 minutes or less. A warning beep
sounds after 10 minutes.
Never use any implements other than the included cleaning sticks. Cotton swabs or other lint-pro-
ducing items may damage the heads. If you use up the cleaning sticks, contact your authorized
Roland DG Corp. dealer.
Use one cleaning stick per cleaning session. Reusing cleaning sticks will reduce the printing quality.
Do not put a cleaning stick that has been used for cleaning into the cleaning liquid. Doing so will
deteriorate the cleaning liquid.
Never rub the nozzle surface of the heads.
Stroke the sponges very gently, applying as little pressure as possible. Never rub, scrape, or crush
them.
If a warning beep sounds during cleaning
A warning beep sounds 10 minutes after operation begins. Stop work, close the front cover, and then
press [ENTER] to end the manual cleaning mode. After that, restart operation from the first procedure.
CAUTION
1.
Change to the print-head manual-cleaning mode.
Remove any media. Close the front cover.
Press [MENU].
MENU
SUB MENU
SUB MENU
MAINTENANCE
Be sure to perform operations as specified by the instructions above,
and never touch any area not specified in the instructions.
Failure to observe this instruction may cause the machine to move suddenly, re-
sulting in injury.
Press [ ] several times until the screen shown on the left
appears.
Press [ ].
Press [ ] twice.
Press [ ].
Periodic Cleaning Maintenance
Chapter 3 Maintenance
61
Advertisement
Table of Contents
