Table of Contents
Advertisement
Media
A d h e s i v e
sheet
Set Height Position of Media (Automatic)
This setup sets the media's height position automatically to a suitable position while printing. While setting up,
the flat table moves automatically and detects the media height when the media touches the head gap sensor.
* If the print surface is uneven, there is a limit to the area of unevenness.
P. 37, "Height Settings When the Print Surface is Uneven"
When you do not want to let the head gap sensor to touch the media, automatic setup is not suitable in the
following cases. Set the height manually.
P. 15, "Set Height Position of Media (Manual)"
Procedure
Secure the media in place on the flat table.
P. 11, "How to Secure the Media"
Close the front cover.
SETUP MEDIA
Press [ ] [ ] [UP] [DOWN] to move the flat table.
Move the print surface to a position 10 mm (0.39 in.) away from the head gap sensor.
This step can be performed with the front cover open.
HEIGHT:XXX.Xmm
Using an adhesive sheet
This method secures the media in place using an
adhesive sheet, which is included. Load the adhe-
sive sheet on the flat table, and press the media on
top of the sheet to set.
The media can be set anywhere as long as it does
not protrude from the flat table.
Press [SETUP].
[SETUP] starts to flash.
Head gap sensor
Basic Operation
10 mm
(0.4 in.)
Media
Chapter 1 Basic Operation
13
Advertisement
Table of Contents
