Load a Preset and Print/Fine-Tune and Print
Procedure
Press [MENU].
MENU
PRESET
LOAD
NAME1
SETUP MEDIA
Open the front cover, and then secure the media in place.
P. 11, "How to Secure the Media"
Press [SETUP].
HEIGHT:000.0mm
PRINT POS.TYPE
CENTER
SCAN:
XXX.Xmm
FEED:
XXX.Xmm
WIDTH :XXX.Xmm
LENGTH:XXX.Xmm
W:XXXmm L:XXXmm
H:XXXmm
Press [ ] twice.
Press [ ] or [ ] to select the name of the preset you want
to load.
Press [ENTER] to confirm your entry.
The screen shown in the figure appears. [SETUP] turns off.
The loaded preset settings are displayed.
To change the height setting of the media
Set height position of media.
P. 13, "Set Height Position of Media (Automatic)"
P. 15, "Set Height Position of Media (Manual)"
When choosing not to change the height setting of the media
Press [ENTER].
The loaded preset settings are displayed.
To change the setting of the print area
Set the print area.
P. 17, "Choosing How to Specify the Print Area"
P. 18, "Specify the Print Area Directly"
P. 19, "Specifying the Print Area from the Print Center Position"
When the setup is completed, proceed to
When choosing not to change the setting of the print area
Press [ENTER].
Press [ENTER].
Press [ENTER].
When the screen shown on the left appears, you can start printing.
Start printing.
P. 23, "Starting the Print Operation"
Chapter 2 Fully Utilizing the Machine
Fully Utilizing the Preset Function
.
33