Table of Contents
Advertisement
When Dot Drop-out Cannot be Cleared Up
SET CARTRIDGE
123456
5, 6 flashes
RENEWING INK...
>>>>>
MENU
INK RENEWAL
Close the ink cartridge cover and the front cover.
Press [MENU], then [ ] to go back to the original screen.
Cleaning All Print Heads
In this operation, all ink within the printer is discharged and the interior is cleaned. Ink is refilled after
cleaning.
This operation requires six unused SOL INK cleaning cartridges (four for cleaning and two for refilling ink).
Have these on hand before you start.
* The effect on white ink and gloss ink is the same as
. If you want to perform maintenance only on white ink and gloss ink, see page 66.
Gloss Ink"
Important notes on this procedure
All ink is discharged in this operation. Perform this operation when all procedures such as "Normal,"
"Medium," "Powerful," and "Manual" cleaning, and measures to improve ink emission flaws (such as
dot drop-out) do not improve the symptoms.
P. 54, "Maintenance That Should Be Performed Daily"
P. 58, "Medium and Powerful Cleaning"
P. 60, "Manual Cleaning"
Be sure to use SOL INK cleaning cartridges. Use of any other type may result in breakdown.
Fill the machine with ink as soon as possible after cleaning is finished. Allowing the machine to stand
without ink may damage the print heads.
Procedure
Discard the discharged fluid.
Perform operations starting from
fluid. The following operations will discharge large amounts of fluid. If you do not empty the drain bottle,
the discharged fluid may overflow.
Press [MENU].
MENU
SUB MENU
66
Chapter 3 Maintenance
When the screen shown on the left appears, insert an ink
cartridge in slots 5 and 6.
P. 65, "When Dot Drop-Out Cannot Be Cleared Up for White or
P. 55, "Disposing of Discharged Fluid"
Press [ ] several times until the screen shown on the left
appears.
Press [ ].
1.
-
to dispose of the discharged
Advertisement
Table of Contents
