Table of Contents
Advertisement
Basic Operation
SCAN:
FEED:
CHECK TABLE
WIDTH :XXX.Xmm
LENGTH:XXX.Xmm
W:XXXmm L:XXXmm
H:XXXmm
Close the front cover.
You can also fine-tune the print area after setup.
P. 36, "Fine-Tuning the Set Print Area"
20
Chapter 1 Basic Operation
XXX.Xmm
XXX.Xmm
When the media touches the head gap sensor, the screen shown
HIGHT
in the figure appears and there will be no setup information in
the machine. Redo from
matic)"
Press [ ] or [ ] to enter the length of the area you want
to print.
Press [ ] or [ ] to enter the width of the area you want
to print.
For a test print, set width to 80 mm or more, and length to 70 mm or
more. An error will occur and test prints cannot be performed if the
area is smaller than this.
Press [ENTER] to confirm your entry.
The print area is specified. The print heads return to the home position.
Make sure the "W" (width), "L" (length), and "H" (height) values on the
menu screen are as intended.
Press [ ] [ ] [ ] [ ] to move the laser point-
er until it points to the center position of
the area you want to print.
Press [ENTER] to confirm your entry.
The print heads return to the home position.
P. 13, "Set Height Position of Media (Auto-
, or
P. 15, "Set Height Position of Media (Manual)"
.
Advertisement
Table of Contents
