Height Settings When the Print Surface is Uneven
This machine can also print on uneven surfaces. However, note the following points regarding the height setting.
Automatically set the height for the highest position of the media.
P. 13, "Set Height Position of Media (Automatic)"
Gap between "highest position of the media" and "lowest position of the print surface" should be 2
mm (78.7 mil) or less (as a general guide).
The print quality at the lower position degrades as the height gap widens.
Highest position
of the media
Lowest position of
the print surface
Printing on a surface that is perpendicular to print heads is not possible.
Print heads
Media
Fully Utilizing the Media Loading Feature
Max. 2 mm (as a general
guide)
Media
Printing on this surface is not possible.
Chapter 2 Fully Utilizing the Machine
37