Fully Utilizing the Media Loading Feature
Fine-Tuning the Set Print Area
Procedure
Specify the print area.
P. 18, "Specify the Print Area Directly"
P. 19, "Specifying the Print Area from the Print Center Position"
Press [FUNCTION].
FUNCTION
PRINT AREA
PRINT AREA
ADJUST
SCAN:
FEED:
WIDTH :XXX.Xmm
LENGTH:XXX.Xmm
W:XXXmm L:XXXmm
H:XXXmm
Description
This feature lets you make fine adjustments of the specified print area. If the specified print area is slightly
displaced from the actual print area on the media, you can adjust the print start position and end position
respectively.
36
Chapter 2 Fully Utilizing the Machine
Press [ ] to display the figure on the left.
Press [ ], then [ ].
Press [ENTER].
Move the laser pointer to the print-start position.
Press [ ] [ ] [ ] [ ], and refine the adjustment of the print-
XXX.Xmm
XXX.Xmm
start position (lower right of print area).
Press [ENTER] to confirm your entry.
Move the laser pointer to the print-end position.
Press [ ] [ ] [ ] [ ], and refine the adjustment of the print-
end position (print area's upper left).
Press [ENTER] to confirm your entry.
Press [FUNCTION] to go back to the original screen.