Placing Documents In The Scanner - Epson SC-T5400 Series User Manual

SC-T5400 Series/SC-T3400 Series/SC-T3400N Series
For information on using the scanner, see the
documentation supplied with the device.
D
Touch Enlarged Copy on the Home screen.
The enlarged copy dialog box is displayed.
Note:
If Enlarged Copy is not displayed on the Home
screen, check the following.
❏ Are the connectors of the USB cable
connecting the printer and scanner inserted
firmly?
❏ Is the power of the scanner on?
❏ Is the scanner a model that supports enlarged
copying?
E
Select the size of the document loaded in the
scanner in Original Size and set the
enlargement setting in Reduce/Enlarge.
If you set Auto Fit Page to On, printing is
performed by automatically enlarging to fit the
width of the roll paper loaded in the printer.
c
Important:
The image quality may decline or streaks may
appear depending on the document or
magnification.
If streaks appear, try performing paper
adjustment.
"Optimizing Paper Settings (Media
U
Adjust)" on page 41
If the problem is not resolved, refer to the
scanner manual and then clean the inside of
the scanner.
User's Guide
Making Enlarged Copies with an A3 or A4 Scanner
Note:
If you touch
to frequently used copy settings and then register
them to Presets.
The screen for entering a name can be switched as
shown below with the button marked.
Also, each touch of the following bottom left icon
switches the input method as follows.
ABC: Enters alphabet letters.
123#: Enters numbers and symbols.
F
Touch the numeric value for the number of
copies and then enter the number of copies in
the keypad screen.
G
Touch to start copying.
Copying can also be started by touching the ]
button of the scanner.
Placing Documents in the
Scanner
Failure to observe the following precautions when
placing the original in the scanner may result in
reduced print quality or scanning failures.
❏ DS-530 is a scanner that scans both sides
simultaneously but it cannot scan both sides of the
document with enlarged copying. Place the side
you want copying facing downward in the ADF.
❏ Be sure to insert the original in landscape (wide)
orientation.
98
(Presets), you can assign a name