Epson SC-T5400 Series User Manual page 122

SC-T5400 Series/SC-T3400 Series/SC-T3400N Series
General Settings - Printer Settings
*Default setting
Settings item
Paper Source Settings
Error Notice
Paper Size Notice
Paper Type Notice
Roll Paper Setup
Detect Paper Me‐
andering
Print Cutting
Guideline
Cut for Borderless
Print
Quick Cut
Using the Menu
Settings value Explanation
On Setting this to On will display an error message when the output size or
paper type settings of print jobs sent to the printer differ from those
*
settings in the printer.
Off
On
*
Off
* If On is selected, an error will be displayed in the control panel and
On
printing will stop if the paper is skewed; select Off to disable this feature.
On is recommended in most circumstances as skewed paper may cause
Off
the printer to jam.
On If Auto Cut is Off, you can choose to print (On) or not print (Off) cut lines
on roll paper. Cut lines are not printed if Auto Cut is On or when cut
*
sheets are used.
Off
Note, however, that if the roll width selected with the computer is
narrower than the paper loaded in the printer, cut lines will be printed
regardless of the option selected for Auto Cut.
The setting selected with the printer driver takes priority when the
printer driver is used.
* Select whether to insert a margin and cut twice between pages (Two
Two Cuts
Cuts) or cut once between pages (One Cut) when printing multiple pages
with borderless printing.
One Cut
The setting selected with the printer driver takes priority when the
printer driver is used.
"About Roll Paper Cutting" on page 66
U
* Specify the cutting operation for printing multiple page jobs.
On
Setting this to On will cut the preceding printout when its trailing edge
Off
reaches the cutting position while the next job is being printed. This
shortens the printing time because printing and cutting are done in
tandem.
The details of the cutting operation are the same as One Cut of Cut for
Borderless Print or Single Cut of the printer driver.
"About Roll Paper Cutting" on page 66
U
Setting this to Off will start the next print job after the preceding print
job is fed to its cutting position and cutting is completed.
User's Guide
122