Epson SC-T5400 Series User Manual page 125

SC-T5400 Series/SC-T3400 Series/SC-T3400N Series
Settings item
Top/Bottom Mar‐
gins
Paper Suction
Back Tension
Drying Time
Drying Time per
Pass
Drying Time per
Page
Using the Menu
Settings value Explanation
* Setting this to Standard will set the top/bottom margins as follows
Standard
depending on the printer driver print targets.
Top 3 mm/Bottom 3
❏
mm
❏
Top 15 mm/Bottom
Left and right margins will remain at 3 mm regardless of settings. If there
15 mm
is any soiling on the top section of the print results, increase the top
margin.
Top 35 mm/Bottom
15 mm
"Printable area" on page 178
U
-4 to +3 It is important to choose the appropriate amount of suction for the paper
used in order to maintain the correct distance between the paper and
print head. Choosing too high a value for thin or soft paper will increase
the distance between the paper and print head too much, causing print
quality to decline or preventing the paper feeding correctly. In such
cases, you will need to lower the paper suction. The lower the setting
value, the weaker the suction power.
* If there is any wrinkling on the paper during printing, select High or
Auto
Extra High.
Standard
When this is set to Extra High, the following setting is enabled.
Settings - General Settings - Printer Settings - Paper Source Settings -
High
Roll Paper Setup - Back Tension 2
Extra High
0.0 to 10.0 seconds Select the time the print head pauses to allow drying after each pass.
* Choose from values between 0.0 and 10.0 seconds. Depending on the
(0.0 )
paper type, the ink may take a while to dry. If the ink blurs on the paper,
set a longer time for drying the ink. Increasing the drying time increases
the time needed to print.
0.0 to 60 minutes Specify how long the printer pauses to allow the ink to dry after printing
* each page; choose from values between 0 and 60 minutes. Depending on
(0.0 )
the ink density or paper type, the ink may take a while to dry. If the ink
blurs on the paper, set a longer time for drying the ink. The longer the
drying time, the more time required for printing.
User's Guide
CAD/Line Drawing: 3 mm/3 mm
Other: 30 mm/30 mm
125