For Cut Sheet(1 Sheet) - Epson SC-T5400 Series User Manual

SC-T5400 Series/SC-T3400 Series/SC-T3400N Series
❏ Tracing Paper
❏ Tracing Paper <LowDuty>
❏ Matte Film
To select a paper type that is not displayed on
the screen, touch Others.
Select a category and select the target paper
type.
Note:
If you scroll downward in the category selection
screen, Custom Paper appears. To select custom
paper that has already been registered, touch
Custom Paper.
D
When a paper type is selected, the screen
returns to the one in step 1.
If you will not set the remaining amount
management setting, touch OK.
E
Touch Paper Remaining.
F
Touch Setup.
The setting changes to On, and Remaining
Amount and Remaining Alert are enabled.
Touch each one and enter a value as follows.
❏ Remaining Amount: Total length of roll paper
(see the manual supplied with the roll paper)
User's Guide
Loading and Setting the Paper
❏ Remaining Alert: Remaining amount value
G

For Cut Sheet(1 sheet)

Configure the following settings after loading cut
sheets.
Settings of Paper Type
This is the most important setting to obtain the
optimum print results. Not setting a paper type that
matches the loaded paper will cause wrinkles, scuffing,
uneven colors, and other trouble.
Settings of Paper Size
Paper size will not be automatically detected. Set the
size of the loaded paper.
38
that will be the timing for displaying the
remaining amount warning notification.
Note:
On the keypad screen for entering a numeric
value, enter numbers that include a number of the
first decimal place. For example, if you want to
enter 5 m, touch [5] and [0].
Touch at the top left of the screen to return
to the screen of step 5 and then touch OK.
You can start printing once Ready appears on
the screen.