Epson SC-T5400 Series User Manual page 129

SC-T5400 Series/SC-T3400 Series/SC-T3400N Series
Settings item
Page Margin
Smoothing
Base Output Size
Using the Menu
Settings value Explanation
* Select the top, bottom, left, and right margin values.
3 mm
For a cut sheet, the top, bottom, left, and right margin values are 3 mm
5 mm
regardless of the settings.
On This setting is enabled when Resolution is set to Standard and there is
no resolution specification in the sent print data. Setting this to On will
*
print at the maximum resolution corresponding to the Paper Type setting
Off
for the paper selected in Paper Source, but depending on the data, this
may result in a long print time, or failures in printing because of
insufficient memory.
* The hard clip area of the PS command of the data becomes the base
Auto
output size. The actual output size depends on the Page Margins option.
When the data does not contain a PS command, the smallest rectangle
area
becomes the base output size.
A Series The compatible standard sizes for the selected Paper Source are
displayed, therefore select the Base Output Size. The actual output size
US-ANSI
depends on the Page Margins option.
For a cut sheet, this setting is available only when the data does not
US-ARCH
contain a PS command. If the data contains a PS command, this setting is
not available, and the hard clip area of the PS command becomes the
B Series (ISO)
Base Output Size.
B Series (JIS)
Others
User-Defined Select this option when outputting at non-standard sizes. After selecting
this setting, set Paper Width and Paper Height. You can set in 0.1 mm
increments.
The actual output size depends on the Page Margins option.
User's Guide
of in the following illustration including the print object
129