Printer Configuration - SATO CX Series Programming Manual

SATO CX Series Printer
Command Command Command Command
Vertical Reference Point
Horizontal Reference Point
Character Pitch
Base Reference Point
Character Expansion
Print Darkness
Print Speed
NOTES:
(1) The settings for these commands will revert to the default value when the
printer receives an <ESC>Z or an <ESC>*.
(2) These values transmitted with these commands will remain in effect until
a new command is received.

PRINTER CONFIGURATION

PRINTER CONFIGURATION
PRINTER CONFIGURATION PRINTER CONFIGURATION
The CX Series printers are different from other SATO models in that they do
not use DIP switches for printer configuration. Instead, all printer configura-
tion is done via software commands. The parameters that can be configured
are:
Sensor Calibration
Protocol Codes
Print Darkness Range
Sensor Type
RS232 Parameters
Label Tear-Off Position
Back-feed Enable/Disable
Because there are no DIP switches to indicate the current printer settings, a
Test Label can be printed that lists the active settings in the printer. This Test
Label lists all of the information a user needs to ascertain the printer configu-
ration. Test Labels can be printed out by sending a command via software
(See page 102) or by using the FEED and On-LINE/Off-Line Indicator buttons
on the control panel (see the CX Series User's Guide).
6
Default Default Default Default
0
0
2
H=0, V=0
1
3
75 mm/second
Note Note Note Note
(1)
(1)
(1)
(2)
(1)
(1)
(2)