SATO CX Series Programming Manual page 26

SATO CX Series Printer
Printer Output:
Special Notes
1. Use of this command will set the Vertical/Horizontal Off-
2. This command may be used more than once in a print
3. An alternative to using this command is to make chan-
Example:
Let's say the current base reference point is H=1, V=1 and
you wish to move all the fields on your label downward ver-
tically by 150 dots. You could either (1) add the Base Refe-
rence Point command or (2) change all the vertical position
commands by an additional 150 dots.
4. For a more detailed example of the Base Reference Point
5. The CX Series printers will not "wrap" (i.e. if any part of a
18
set setting of the printer configuration until a new Base
Reference Point command is issued.
job.
ges to your current Horizontal and Vertical Print Position
commands (See page 57).
command, see "Print Area" in this section(See page 5).
character or image extends beyond the last print dot
position, it will disappear and not be visible on any part
of the label).