Lcd Panel Printer Configuration - SATO M-8400RVe Operator And Technical Reference Manual

LCD PANEL PRINTER CONFIGURATION

The LCD Panel is used by the operator in conjunction with the LINE and FEED
switches to manually enter printer configuration settings. Many of these settings can
also be controlled via software commands and in the case of conflict between
software and control panel settings, the printer will always use the last valid setting
(see Service Mode Priority Setting on page 3-22 for exceptions). If you load a label job
that includes software settings and then enter a new setting via the LCD panel, the
manually set values will be used by the printer. If you set the values manually and
then download a job with software settings, the software settings will be used.
There are seven modes of operation. To enter the desired mode, the KEY SEQUENCE
combination listed in the table below must be performed. The initial LCD display
message is shown for each mode.
MODE
Normal
Advanced
Test Print
Default Setting
Clear Non-Standard Protocol
Protocol Code Download
Hex Dump
SATO M8400RVe
KEY SEQUENCE
POWER
LINE + POWER
FEED + POWER
LINE + FEED + POWER
DSW2-7 ON + LINE + FEED
+ POWER
DSW2-7 ON + POWER + LINE
DSW2-4 ON + POWER
PN 9001075A
Section 3: Configuration
INITIAL DISPLAY
ONLINE
QTY:000000
ADVANCED MODE
TEST PRINT MODE
CONFIGURATION
DEFAULT SETTING
YES NO
ALT. PROTOCOL
COMPLETE
USER DOWNLOAD
PRESS THE LINE KEY
ONLINE
QTY:000000
PAGE
3-10
3-12
3-23
3-23
3-25
3-25
3-26
Page 3-9