Lcd Panel Printer Configuration - SATO M-84PRO Operation Manual

Section 3. Configuration

LCD PANEL PRINTER CONFIGURATION

The LCD Panel is used by the operator in conjunction with the LINE and FEED
switches to manually enter printer configuration settings. Many of these settings can
also be controlled via software commands and in the case of conflict between
software and control panel settings, the printer will always use the last valid setting. If
you load a label job that includes software settings and then enter a new setting via
the LCD panel, the manually set values will be used by the printer. If you set the
values manually and then download a job with software settings, the software
settings will be used.
NORMAL MODE
The printer initially powers on in the ONLINE mode. The user can access the User
Settings using the following procedures.
V 05.00.03.00
INITIALIZING
ONLINE
QTY:000000
OFFLINE
PRINT DARKNESS
1 2
PRINT SPEED
2 4
Page 3-10
Displays the firmware during the initialization.
The LCD will display the ONLINE status on the top line and the
bottom line will contain the label quantity (QTY) status. The
messsge will be changed to OFFLINE whenever the printer is
switched offline by pressing the LINE key. As soon a print job is
received, the quantily line will indicate the number of labels to
be printed. As soon as the label job begins to print, the display
will indicate the number of labels in the print job that remains to
be printed.
Press the LINE key once. When the display changes to
000000 OFFLINE, press the FEED and LINE keys simultaneously for
more than one second. Release the keys.
The LCD now displays the Print Darkness selections. The
3 4 5 current setting is indicated by a cursor over one of the range
settings. There are 5 possible selections. The lowest setting
represents the lightest print and the highest setting the darkest
print.
1. Press the Cursor keys to step the cursor to the desired
setting.
2. Once the correct setting is underlined, press the ENTER
key to accept the selection and step the display to the next
adjustment.
The print speed selections are dependent upon the printer
6 8 10 model. The current setting is indicated by the cursor.
1. Use the Cursor keys to step the cursor to the desired
setting.
2. Once the correct setting is selected, press the ENTER key
to accept the selection and step the display to the next
adjustment.
Operation Manual
SATO M-84PRO