SATO CX Series Programming Manual page 100

SATO CX Series Printer
Printer Output
Special Notes
1. When the code words per line and the number of rows
2. If the product of the values entered for "dd" and "ee" are
3. The values for "dd" and "ee" need to be made larger if
4. The maximum data length is 2700 characters, but may
5. The Reference Point of the PDF417 symbol is the upper-
6. The <ESC>F Sequential Numbering command cannot
7. The <ESC>E Line Feed command cannot be used with
8. The Macro and Truncated PDF417 symbols are not sup-
9. The values 00H thru 1FH can be specified as print data.
10. This command can be stored in a format.
11. The <ESC>R Rotate command can be used.
92
per symbol ("dd" and 'ee") are set to all zeroes, the prin-
ter will calculate the optimum configuration.
not equal to or less than the value of "fff" (i.e.,"ffff" is
greater that "dd" x "ee"), an error will occur and the
symbol will not be printed. It is recommended that these
values each be set to "000" and the printer be allowed
to automatically calculate the optimum values.
the security level is increased.
be less depending upon:
- the minimum module dimension ("aa")
- the security level specified by "c".
- the number of data characters
left corner.
be used with this command.
this command.
ported.