Show Flexconnect Wlan - Cisco Aironet Wave 2 Cli Command Reference Manual

show flexconnect wlan

show flexconnect wlan

To view the WLAN configuration for Flexconnect AP mode, use the show flexconnect wlan command.
show flexconnect wlan [{l2acl |qos |vlan}]
Syntax Description
l2acl
qos
vlan
User EXEC (>)
Command Modes
Privileged EXEC (#)
Command History
Release
8.1.111.0
The following example shows how to view the WLAN Layer 2 ACL mapping for the Flexconnect
AP:
cisco-wave2-ap# show flexconnect wlan l2acl
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
112
Specifies the Layer 2 ACL mapping for WLAN
Specifies the QoS parameters for WLAN
Specifies the VLAN mapping for WLAN
Modification
This command was
introduced.
show Commands