Debug Cleanair - Cisco Aironet Wave 2 Cli Command Reference Manual

debug cleanair

debug cleanair

To configure debugging of CleanAir, use the debug cleanair command.
debug cleanair {bringup | event | logdebuglow | major | nsi | offchan {0 | 1}}
Syntax Description
bringup
events
logdebug
low
major
nsi
offchan 0 | 1
Privileged EXEC (#)
Command Modes
Command History
Release
8.1.111.0
Examples
The following example shows how to enable debugging of major CleanAir events:
cisco-wave2-ap# debug cleanair major
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
50
Enables debugging of CleanAir port or bringups
Enables debugging of normal CleanAir events
Logs CleanAir debug output to a logfile
Enables debugging of hex dump of some messages
Enbles debugging of major CleanAir events
Enables debugging of NSI messages
Enables debugging of CleanAir MSMT requests. You have to specify the radio slot as either
0 or 1
Modification
This command was
introduced.
debug Commands