Debug Mesh - Cisco Aironet Wave 2 Cli Command Reference Manual

debug Commands

debug mesh

To configure debugging of mesh networks, use the debug mesh command.
debug mesh {channel |clear |convergence |events |forward-mcast |forward-packet |forward-table
|linktest |path-control |port-control |security |trace}
Syntax Description
channel
clear
convergence
events
forward-mcast
forward-packet
forward-table
linktest
port-control
security
trace
Privileged EXEC (#)
Command Modes
Command History
Release
8.1.111.0
Examples
The following example shows how to enable debugging of mesh channel:
cisco-wave2-ap# debug mesh channel
Configures debugging of mesh channel
Resets all mesh debugs
Configures debugging of mesh convergence
Configures debugging of mesh events
Configures debugging of mesh forwarding Multicast
Configures debugging of mesh forwarding packets
Configures debugging of mesh forwarding table
Configures debugging of mesh linktest
Configures debugging of mesh port control
Configures debugging of mesh security
Configures debugging of mesh trace
Modification
This command was
introduced.
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7

debug mesh

65