Debug Flexconnect - Cisco Aironet Wave 2 Cli Command Reference Manual

debug Commands

debug flexconnect

To debug FlexConnect features, use the debug flexconnect command.
debug flexconnect {acl | cckm | dot11r | event | multicast {igmp | traffic} | pmk |
proxy-arp | vsa | wlan-vlan | wsastats}
Syntax Description
acl
cckm
dot11r
event
multicast igmp
multicast traffic
pmk
vsa
wlan-vlan
wsastats
Privileged EXEC (#)
Command Modes
Command History
Release
8.1.111.0
Examples
The following example shows how to enable debugging of FlexConnect ACL:
cisco-wave2-ap# debug flexconnect acl
Configures debugging of FlexConnect ACL
Configures debugging of CCKM
Configures debugging of 802.11r
Configures debugging of wireless control protocol (WCP) events
Configures debugging of Multicast IGMP
Configures debugging of Multicast traffic
Configures debugging of opportunistic key caching (OKC) or pairwise master key caching
Configures debugging of AAA vendor specific attributes (VSA)
Configures debugging of WLAN-VLAN mapping
Configures debugging of RADIUS or DHCP wireless service assurance statistics
Modification
This command was
introduced.
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7

debug flexconnect

59