Rinnai RIB2312L Operation & Installation Manual page 39

Step 3. Installing the Log Set and Burner Granules
For clarity the drawings are displayed without showing the entire heater.
DO NOT remove the burner from heater engine to install the log set.
NOTE
Use extreme care when handling the Log Set components, they are made from a very fragile high
temperature material and will damage if handled roughly. Only remove the components from
their packaging as required.
Check to ensure that the ports of the burner are
clean and clear of any particles and all packaging
material. The log set MUST BE installed in the precise
order as stated.
Log the short straight log with a single locating pin.
2
Place the log onto the sheet metal tabs at the left and
rear of the burner box. When correctly positioned this
log will be touching the left and rear burner box walls.
1
Log . long log with a single locating hole. Line up the
4
hole with the pin of log
this log will be touching log
and the burner.
Rinnai
BURNER MEDIA INSTALLATION
2
1
4
. When correctly positioned
1
, the rear burner box wall
1
Log thick 'Y' shaped log with two locating holes and
1
pins. Line up the holes with the pins of the bracket fixed
to the centre of the burner. When correctly positioned
the log rests on this bracket.
2
Log thinner 'Y' shaped log with two locating holes.
3
Line up the holes with the pins of logs
When correctly positioned the log rests on both logs
and .
2
Log bowed log with a single locating hole. Line up
5
the hole with the pin bracket to the right of the burner
and locate the front of log onto the stop bracket. When
correctly positioned this log will be touching both
brackets, log and the right burner box wall.
4
39
1
3
1
1
5
4
SAPPHIRE RIB2312 OIM
and .
2
1