Replacing The Cr2450 Button Batteries; Lost, Misplaced Or Broken Remote Control - Rinnai RIB2312L Operation & Installation Manual

REPLACING THE CR2450 BUTTON BATTERIES

When this low power symbol appears the batteries are near to being fully discharged and are
unable to power the remote control properly. Replacement of batteries is now required.
1.Using a suitable lever remove the back cover by carefully prying off the back cover at the 6 pry
points
Note: Remote contol is shown with back cover removed for illustrative purposes
2. Remove the two bridge retaining screws,
3. Remove the bridge
4. Remove the old batteries
was created when the bridge
5. Insert two new batteries
6. Reassemble the bridge in reverse order as per steps 2 & 3 above.
7. Re-attach the rear cover by carefully clipping it back into place.

LOST, MISPLACED OR BROKEN REMOTE CONTROL

In the event of a lost, misplaced or broken remote control the appliance may still be operated in a limited capacity.
By using the manual control panel,
1
The heater will automatically modulate between flame settings to maintain the default set temperature of 22°C.
No control of the flame or heat output is possible via the appliance ON/OFF button.
NOTE
Rinnai
REMOTE CONTROL OPERATION
.
f
f
g
.
h
by carefully sliding them out from under the retainers
i
was removed in step 3.
h
(CR2450), ensuring the positive "
i
power ON/OFF button
1
g
g
h
using a small (No.0) Phillips head screw driver or equivalent.
+
" terminals are facing up.
, located on the top left hand side of the heater.
a
1
14
i
i
j
, and into the space that
j
a
b
1
SAPPHIRE RIB2312 OIM
j