Rinnai RIB2312L Operation & Installation Manual page 34

Step 4. Attach Spigot Adaptor & Panels
Assemble the spigot adaptor halves
4 x screws (supplied).
with
Drill 4 x Ø 3.2mm holes in the pre pressed location dimples on the
top and back of the heater engine, then fit the flue spigot adaptor
to the heater engine top and rear panels using 4 - 8g x 10mm
G
self tapping screws (supplied).
Fit the rear panel
H
(supplied).
Before attempting to fit the side panels it is
necessary to elevate the heater engine by 100mm.
IMPORTANT
Fit side Panels and
I
panel using 12 - 8g x 10mm self tapping screws (supplied).
Carefully align top panel
to the heater at the front using 3 - M5 x 12mm screws (supplied)
and at the rear using 3 - 8g x 10mm self tapping screws
(supplied).
Step 5. Prepare Gas Supply
Remove the threaded brass plug from the S/S flexi pipe consumer
gas supply pipe.
Step 6. Fit Heater Engine To Pillar Assembly
This installation step requires a two man lift. Seek
assistance before proceeding further.
WARNING
Carefully lift the heater engine assembly
assembly ensuring that the gas supply pipe and fittings
D
feed into the rear access hole
Take care that the electrical cord does not bunch up
or get pinched behind the heater engine.
CAUTION
Align the heater securing holes over the M5 root nuts, then secure
using the 4 - M5 x 12mm screws supplied. Note that two screws
are located midway into the appliance on the lower left and right
edges, refer to detail
M
M
Step 7. Connect Electrical Supply
Plug in 3 pin connector, if a general purpose outlet (power point)
is used.
Step 8. Connect Gas, Go to page 37
Rinnai
HEATER ENGINE INSTALLATION
and
G1
using 9 - 8g x 10mm self tapping screws
to heater body at the front and the rear
J
over tabs of the rear panel
K
below.
M M
, secure together
G2
, fasten
H
onto the plinth
L
E
34
G1
G2
L
D
G
H
J
I
K
H
E
SAPPHIRE RIB2312 OIM