Remote Control Operation; Batteries And Activating The Remote Control; Button Functions, Display & Operation - Rinnai RIB2312L Operation & Installation Manual

For the remote control to be able to function, the appliance ON/OFF button
position. Using the remote control to turn off the heater will place the heater into STANDBY mode,
IMPORTANT
when in this mode the Red Power Indicator
y WARNING KEEP BATTERIES OUT OF REACH OF CHILDREN.
y
Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns
and potential perforation of the oesophagus.
y
If you suspect your child has swallowed or inserted a button battery immediately call the
24-hour Poisons Information Centre on 13 11 26 for fast, expert advice.
y
Examine devices and make sure the battery compartment is correctly secured, e.g.
that the screws or other mechanical fasteners are tight. DO NOT use if compartment is not secure.
y
Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous and may be a choking hazard.
y
Inform others about the risk associated with button batteries and how to keep their children safe.
y
Remove the batteries if the remote is not going to be use for prolonged periods. This will help prevent damage from leaking
batteries. If leakage has occurred and corrosion is evident the remote will need to be replaced.
y
Leaking chemicals are toxic and MUST NOT be touched or ingested.
y
NEVER mix old and new batteries.
y
DO NOT immerse the remote control in any liquid, this will damage the remote control, rendering it inoperable and voiding
its warranty.

BATTERIES AND ACTIVATING THE REMOTE CONTROL

• 2 x Button Batteries are supplied with the remote control.
• Remove the plastic tab to activate.
• This remote control uses 2 x Lithium CR2450 or equivalent batteries.
• The appliance will flash and emit 'Beeps' to confirm the setting has been received from the remote control unit;
this indicates your remote control is now working.
BUTTON FUNCTIONS, DISPLAY & OPERATION
This remote control,
8
in five levels.
The STANDBY / ON button
the STANDBY and ON modes.
Flame height may only be adjusted after at least 30
seconds of operation.
The UP / DOWN buttons
and heat output.
The relationship between flame height and fan speed is
factory preset and cannot be adjusted, there are five flame /
fan settings as listed below.
Flame Height
Fan Speed
(2 speed only)
On initial start-up the appliance default flame
height setting is setting 5 - High. Use the UP /
NOTE
DOWN buttons
flame / heat output.
The remote control temperature sensor (located base of the
controller) reads the temperature of where control is
currently located, this temperature reading is refreshed once
a minute.
The degrees Celsius room temperature display
remain illuminated for approximately 5 seconds after a movement is sensed or when a button is
NOTE
pressed. Frequent illumination of the back light greatly reduces the remote controls operational
battery life, ensure that unnecessary illumination of the display is avoided.
Rinnai

REMOTE CONTROL OPERATION

selects flame height and fan speed
switches the heater between
c
control the height of the flame
d
1 2 3
Low Low Low High High
to control the height of the
d
will be on. This is normal.
b
1
4 5
1
has a motion activated back light which will
e
13
must be in the "ON"
a
a
b
1
c
d
8
SAPPHIRE RIB2312 OIM