Ricoh IS300e Operating Instructions Manual page 79

❒ When you select [Custom Resolu-
tion], you can specify the resolu-
tion within the range of 100dpi
through 1200dpi in 1dpi incre-
ments.
❖ ❖ ❖ ❖ Scan Size
This item lets you select the size of
the area to be scanned. You can se-
lect from the following options.
Auto Detect, A3S, A4S, A4R,
A5S, A5R, 11x17S, 8
x 1 3 S , 8
1
8 /
2
x 1 1 S , 5
1 1
8 /
2
S, B4JIS (Japanese In-
1 1
5 / x8 /
2 2
dustrial Standard)S, B5JISS,
B5JISR, Custom Area Setting
Note
❒ Original sizes that can be auto-
detected vary depending on
where you place the originals
(on the exposure glass or on the
ADF). See ⇒ p.110 "The Origi-
nal Sizes Available for Auto De-
tection" for details.
❒ When [Custom Area Setting] is se-
lected, specify the scanning area
for [Start Positn.] and [Scanning
Area].
❖ ❖ ❖ ❖ Position
Specify the position where scan-
ning starts when [Custom Area Set-
ting] is selected in the [Scan Size]
list.
Enter the offset from the reference
(start) point in millimeters or inch-
es.
Note
❒ This setting is enabled only
when [Custom Area Setting] is se-
lected in the [Scan Size] list.
❒ You can select millimeters or
inches to specify the position
using [Unit of Measure] in [2.Send-
Scan Settings] under the Scanner
Features menu. See ⇒ p.61
"Unit of Measure" for details.
1
/ x14S,
2
x 1 1 R S ,
1
/
2
R ,
1
/ x 8 /
2 2
Registering Scan Settings
❖ ❖ ❖ ❖ Scanning Area
Specify the position where scan-
ning ends when [Custom Area Set-
ting] is selected in the [Scan Size]
list.
Enter the offset from the position
specified for [Start Positn.], in mil-
limeters or inches.
Note
❒ This setting is enabled only
when [Custom Area Setting] is se-
lected in the [Scan Size] list.
❒ You can select millimeters or
inches to specify the position
using [Unit of Measure] in [2.Send-
Scan Settings] under the Scanner
Features menu. See p.61 "Unit
of Measure" for details.
❒ Make sure that you specify ver-
tical/horizontal positions and
scanning areas to be within the
available scan area. The availa-
ble scan area varies depending
on where you place the origi-
nals (on the exposure glass or
on the ADF).
3
71