Ep Setup - Konica Minolta Bizhub 4700P Service Manual

Note: The Permanent Page Count value cannot be reset.
Processor ID
This is a 16-digit hexadecimal value representing the ID of the processor on the controller card.
Engine Setting [x]
These settings are used by Engine code ECs to fix field problems. The value of [x] is any value from 1
to 16.
Edge to Edge
When set to On, this shifts all four margins (top, bottom, left, and right) to the physical edge of the page
(printable area of a supported paper size). This feature does not work in PPDS emulation.

5.3.11 EP Setup

EP Defaults
This setting restores each printer setting listed in EP SETUP to its factory default value. Sometimes this
is used to help correct print quality problems.
To restore the EP defaults:
1. From the Diagnostics menu, navigate to:
EP Setup >EP Defaults
2. Select Restore to restore the default values, or press
Fuser Temperature (Fuser Temp)
This setting adjusts the fuser temperature to solve problems with paper curl on low-grade paper and/or
melting of letterheads on some papers.
To adjust this setting:
1. From the Diagnostics menu, navigate to:
EP Setup >Fuser Temp
2. Press [OK] to save any changes.
Transfer Adjust
This setting controls the transfer roll algorithm.
To adjust this setting:
1. From the Diagnostics menu, navigate to:
EP Setup >Transfer Adjust
2. Press [OK] to save any changes.
bizhub 4700P/bizhub 4000P Service Manual
- 156 -
to exit without changing the settings.