Konica Minolta Bizhub 4700P Service Manual page 57

202 paper jam messages
Error code Description
202.01 Exit sensor is covered during warm up.
202.03 Media did not reach the fuser exit sensor.
202.05 Fuser exit sensor covered too long by the
current sheet.
202.07 Fuser exit sensor covered too long by the
previous sheet.
202.13 Restart attempted after an internal jam without
cover open. Close event. Likely that the jam
was not actually cleared.
202.14 Expected banner sheet ( assumed wide ) not
detected by Narrow media/bin full sensor,
possible accordion jam, unsupported narrow
banner media, or missing signal.
202.16 Page at fuser nip before fuser started ramping
toward desired. Indicates code may be
receiving more hall interrupts than intended.
202.17 Page at fuser nip before fuser reached
acceptable operating temperature. Page
arrived at fuser earlier than expected, so it
was probably staged.
202.22 Cartridge Motor - Motor Underspeed Error.
Motor made it to closed loop steady state, but
then detected speed was below threshold.
202.28 Exit sensor bounce issue.
202.32 The sheet is too long to be duplexed. The
blow through is enabled.
202.36 Long paper or shingled multi feed stopped
before sending to duplex.
202.43 During warm up flush, media that passed the
input sensor failed to reach the exit sensor.
202.45 During warm up flush, sheet detected too
long over exit sensor.
bizhub 4700P/bizhub 4000P Service Manual
- 56 -
Action
Go to Sensor (fuser exit) jam service
Go to Sensor (fuser exit) jam service
Go to Sensor (fuser exit) jam service
Go to Sensor (fuser exit) jam service
Go to Sensor (fuser exit) jam service
Go to Sensor (fuser exit) jam service
Go to Sensor (fuser exit) jam service
Go to Sensor (fuser exit) jam service
Go to Sensor (fuser exit) jam service
Go to Sensor (fuser exit) jam service
Go to Duplex service check.
Go to Duplex service check.
Go to Sensor (fuser exit) jam service
Go to Sensor (fuser exit) jam service
check.
check.
check.
check.
check.
check.
check.
check.
check.
check.
check.
check.