Table of Contents
Advertisement
Settings via software
Editing a sewing pattern / contour test: Value 4
Fig. 30: Editing a sewing pattern
1. Press the +/- Function buttons to set value 4.
2. Press the Selection button.
The Program display shows a 1 for the first stitch; the Function dis-
3. Press the +/- Function buttons to set the coordinates of the 1st stitch
4. Press the Selection button.
The Y-axis LED illuminates; the Function display shows the value
5. Press the +/- Function buttons to set the coordinates of the 1st stitch
6. Press the +/- Program buttons to select the next stitch.
7. Repeat steps 3 to 5 for all additional stitches.
8. Press the Ready button to save the edited sewing pattern.
9. Press the Reset button.
The LED in the button switches off.
10. Press the USB button.
The LED in the button switches off.
11.23Error messages
If an error occurs, the Error LED illuminates.
Error
E
E
E
Service Instructions 512-211-01/532-211-01 - 00.0 - 06/2016
play shows the value for the X-axis; the X-axis LED illuminates.
for the X-axis.
for the Y-axis.
for the Y-axis.
Description
8 Error table data Unable to read the table
1 0 Error sewing
pattern number
3 0 Error needle
bar position top
Possible cause
data
The selected sewing pat-
tern is not saved in ROM or
is set to non-readable. The
sewing pattern is "0"
The needle bar is not at the
top position
Remedy
Save the table data
again.
Press the Reset button to
confirm the sewing pat-
tern number.
Check the connections.
Turn the needle bar to
the top dead center posi-
tion.
51
Advertisement
Table of Contents
