Editing Sewing Patterns Externally - DURKOPP ADLER 512-211-01 Service Instructions Manual

1. Press and hold the Memory button for 6 seconds.
 The LED in the button illuminates.
2. Select parameter number U085 by using the +/- Program buttons.
3. Press the Ready button.
4. Enter the function value 1 by using the +/- Function buttons.
 Press the Selection button.

11.21Editing sewing patterns externally

Sewing patterns can be created and edited externally on a PC, e.g. using
MS Excel or a text editor.
Each row represents a stitch coordinate in an X and Y-direction. The ma-
ximum size of a sewing pattern is 400 x 300 x 1/10 mm.
Negative values or comma separated values should not be entered.
The operator does not have to perform any calculations to center the se-
wing pattern. The machine automatically centers the sewing pattern in the
middle of the sewing field. To subsequently move the sewing pattern, see
chapter storing sewing patterns ( S. 43).
Fig. 28: Example of stitch coordinates in MS Excel or a text editor
(1) - Starting point/first stitch
48
NOTICE
Property damage may occur!
Damage to the clamp if the sewing field size does not match the
clamping feet.
Check the clamping foot, adjust if necessary.
①
②
(2) - End point/last stitch
Service Instructions 512-211-01/532-211-01 - 00.0 - 06/2016
Settings via software