Stopping Sewing; Editing Parameters In The Memory; 1Editing Parameters In Level M1 - DURKOPP ADLER 512-211-01 Service Instructions Manual

11.18Stopping sewing

1. Press the Ready button.
 The LED in the button illuminates. The control unit is in the sewing
2. Set main switch to OFF.
Note
If the automatic sewing machine is switched off without pressing the Rea-
dy button, any modified values will not be saved.

11.19Editing parameters in the memory

11.19.1Editing parameters in level M1

Prerequisite:
• The machine is in the programming mode, the LED in the Ready button
1. Press and hold the Memory button for 3 seconds.
 The controller beeps 1x; the LED in the button illuminates.
2. Press the +/- Program buttons to select other parameters.
3. Press the Ready button to confirm the parameter.
 The LED in the button illuminates.
4. Press the +/- Function buttons to change values.
5. Press the Reset button to reset a changed value.
6. Press the Ready button to save a change.
 The LED in the button switches off.
7. Press the Memory button.
 The LED in the button switches off.
46
VORSICHT
Risk of injury from sharp and moving parts!
Puncture or crushing possible.
Do not place your hand below the raised clamp.
mode.
is off.
The Program display shows the parameter numbers; the Function
display shows the parameter values.
Service Instructions 512-211-01/532-211-01 - 00.0 - 06/2016
Settings via software