Adjusting The Height Of The Fabric Clamp Lift - DURKOPP ADLER 512-211-01 Service Instructions Manual

7
The following maximum heights apply when adjusting the fabric clamp lift:
• Max. height for class 512: 15 mm
• Max. height for class 532:
Cover
1. Remove the arm cover ( S. 14).
Fig. 21: Adjusting the height of the fabric clamp lift
(1) - Screw
Adjusting steps
1. Loosen the screw (1).
2. Adjust the height by turning the fabric clamp lift on the shaft. When
3. Tighten the screw (1).
Order
After changing the height of the fabric clamp lift always check the setting
of the thread wiper as well.
30

Adjusting the height of the fabric clamp lift

WARNING
Risk of injury from sharp and moving parts!
Crushing hazard and puncturing injuries due to
moving and sharp parts.
Switch off the sewing machine before adjusting the
fabric clamp lift.
• 13 mm (Standard button clamp)
• 7 mm (Universal button clamp without shank shaper)
• 5 mm (Universal button clamp with shank shaper)
doing this observe the values for the maximum height.
Adjusting the height of the fabric clamp lift
①
Service Instructions 512-211-01/532-211-01 - 00.0 - 06/2016