Error Messages - DURKOPP ADLER 967 Operating Instructions Manual

Troubleshooting
Operating Instructions 967 - 02.0 - 11/2016

10.2.2 Error messages

Code Possible cause
1000 Sewing motor encoder plug
(Sub-D, 9-pin) not
connected
1001 Sewing motor error: Sewing
motor plug (AMP) not
connected
1002 Sewing motor insulation
fault
1004 Sewing motor error:
Incorrect sewing motor
direction of rotation
1005 Motor blocked
1006 Maximum speed exceeded • Replace the encoder
1007 Error in the reference run
1008 Encoder error
Remedial action
• Connect encoder cable to
the control, use correct
connection
• Check connection and plug
in, if necessary
• Test sewing motor phases
(R= 2.8 Ω, high impedance
to PE)
• Replace the encoder
• Replace sewing motor
• Replace the control
• Check motor phase and
PE for low-impedance
connection
• Replace the encoder
• Replace sewing motor
• Replace the encoder
• Check plug assignment
and change, if necessary
• Test motor phases and
check for correct value
• Eliminate stiff movement in
the sewing machine
• Replace the encoder
• Replace the motor
• Perform reset
• Check machine class
(parameter t 51 04)
• Replace the encoder
• Eliminate stiff movement
in the sewing machine
• Replace the encoder
117