Status And Error Messages - DURKOPP ADLER 867 Instruction Manual

7.5 Status and error messages

V8 0 V820
InF A1 InFo A1
StoP Symbol „G"
flashes “cut out”
InF A3 InFo A3
InF A5 InFo A5
V8 0 V820
jumps InFo F1
back to
1st digit
V8 0 V820
InF E1 InFo E1
InF E2 InFo E2
InF E3 InFo E3
InF E4 InFo E4
InF H1 InFo H1
InF H2 InFo H2
42
All manuals and user guides at all-guides.com
General information
Meaning
The pedal is not in its zero position when the sewing drive is
switched on
The cut-out is active
Reference position not stored
For programming see set-up instructions
No valid Autoselect resistance detected
For information see set-up instructions
Programming error message
Meaning
Incorrect code or parameter number entered
Hardware and software error messages
Meaning
After main switch on:
proximity or commutation switch
defective or connection lead wrongly connected
During or after a sewing run:
proximity switch defective
Mains voltage too low or the time between
main switch OFF and main switch ON was too short
Machine is blocked or not reaching the required rotation speed
Control disrupted by defective earthing or defective plug
connections (contact error)
Commutation-switch lead is defective or the power electronics
for the generation of the rotating field is faulty
Processor faulty