Standards Pm240M - Siemens Sinamics G110M Original Instructions Manual

Appendix
A.8 Standards PM240M
Name
SI forced dormant error detection timer
SI forced checking procedure STO via PM terminals time
Table A- 14 Safety logbook
Name
SI checksum to check changes
SI checksum to check changes
SI change control time stamp
SI change control time stamp
A.8

Standards PM240M

SEMI F47
330
European Low Voltage Directive
The SINAMICS G110M product range complies with the requirements of
the Low Voltage Directive 2006/95/EC. The units are certified for com-
plaince with the following standards:
EN 61800-5-1 — Semiconductor inverters –General requirements and line
commutated inverters
EN 60204-1 — Safety of machinery –Electrical equipment of machines
European Machinery Directive
The SINAMICS G110M inverter series does not fall under the scope of the
Machinery Directive. However, the products have been fully evaluated for
compliance with the essential Health & Safety requirements of the directive
when used in a typical machine application. A Declaration of Incorporation
is available on request.
European EMC Directive
When installed according to the recommendations described in this manual,
the SINAMICS G110M fulfils all requirements of the EMC Directive as de-
fined by the EMC Product Standard for Power Drive Systems EN 61800-3
Underwriters Laboratories
UL and CUL RECOGNIZED POWER CONVERSION EQUIPMENT for use
in a pollution degree 2 environment.
Specification for Semiconductor Process Equipment Voltage Sag Immunity
SINAMICS G110M Inverters fulfill the requirements of the SEMI F47-0706
standard.
Number Value
p9659 <p9659_v>
p9661 <p9661_v>
Number Value
r9781[0] <r9781[0]_v>
r9781[1] <r9781[1]_v>
r9782[0] <r9782[0]_v>
r9782[1] <r9782[1]_v>
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD