Machine/Vpanel Problems; The Power Does Not Turn On; Initial Operations Are Not Performed Or Fail; Vpanel Doesn't Start Correctly - Roland MDX-50 User Manual

Machine/VPanel Problems

The Power Does Not Turn On

Has the emergency stop button been
pressed?

Initial Operations Are Not Performed or Fail

Is the front cover or the dust box cover
open?
Is a large amount of cutting waste
present?
Is anything caught on the spindle head
or table?
Is the tool bur caught on anything?

VPanel Doesn't Start Correctly

Have the initial operations been com-
pleted?
Is the computer connected to the
machine?
Is the driver installed correctly?
Are multiple machines connected to a
single computer?
If the emergency stop button has been pressed, the power will
not turn on. Release the emergency stop button.
P. 13 "Emergency Stop or Pause Due to Opening or Closing the
Cover"
Keep the front cover and the dust box cover closed when starting
the machine. For safety, the initial operations are not performed
if a cover is open when the machine starts.
Clean away any cutting waste. Clean the area around the spindle
head especially carefully.
P. 31 "Cleaning after Cutting Finishes"
Check whether something has become caught and is impeding
the initial operations.
The machine may not be able to perform the initial operations if
the tool bur attached to the spindle unit is caught on the rotary
axis unit or workpiece. Try to detach the tool bur using the built-in
panel's emergency release function.
P. 71 "When the Machine Stops with the Tool Bur Inserted in the
Workpiece"
Before you start VPanel, first switch on the power to the machine.
P. 7 "Displaying VPanel"
Check whether the connector cable has come loose.
If the connection to the computer is not made according to the
procedure described, the driver will not be installed correctly.
VPanel will not function normally if the driver is not configured
correctly. Check again to ensure that the connection was made
using the correct procedure.
"Setup Guide" ("Installing the Windows Driver")
VPanel cannot control multiple machines at the same time. Never
connect multiple instances of this machine to a single computer.
7. Troubleshooting
69