Adjusting The Feeding Speed/Spindle Rotating Speed During Cutting - Roland MDX-50 User Manual

3. Cutting
When the sending of the cutting data is complete, you can disconnect this machine from the PC.
The machine can temporarily save in its internal memory the cutting data sent from the PC. Therefore, when the
sending of the cutting data is complete, you can use the PC with the USB cable disconnected.
CAUT I O N
Do not disconnect the machine and the PC when
When
being received, so you cannot
remove the cable.

Adjusting the Feeding Speed/Spindle Rotating Speed during Cutting

You can use the built-in panel to adjust the feeding speed and the number of rotations of the spindle during cutting.
Built-in panel
" P.46 "How to Set Overrides"
28
3. Cutting (One Side Cutting)
is displayed, data is
is displayed on the built-in panel.
When disappears, you can
remove the cable.