Attach/Detach Tool" Dialog Box; Sensing Z Origin" Dialog Box - Roland MDX-50 User Manual

"Attach/detach tool" Dialog Box

- [Cutting Machine] tab - [Attach/detach tool]
Stocker No.
Tool selection
Replace
Return
Tool force
Release
release

"Sensing Z origin" Dialog Box

- [Origin] tab - [Set origin using Z0 sensor] - [Set]
Start sensing
Abort
Select the ATC magazine stocker number of the tool bur to grasp. The name
of the tool bur whose number is selected is displayed in the box on the right.
Obtain the tool bur from the ATC magazine. If the spindle is holding a tool
bur, this tool bur is returned to its stocker, and then the tool bur of the se-
lected stocker is obtained.
Return the tool bur to the ATC magazine.
Click this to forcibly release the tool bur in an emergency. Check whether
it is OK to release the tool bur once more. The retained tool bur is released
above its stocker.
Start the detection of the Z origin. When the origin is detected correctly, the tool bur
raises to its upper limit and moves to the standby position.
Cancel the detection of the Z origin. The previous Z origin is retained.
"Settings" Dialog Box
6. VPanel Operation (Practical Use)
59