Quickly Moving To A Specific Position - Roland MDX-50 User Manual

Built-in Panel Functions

Quickly Moving to a Specific Position

Use this procedure to quickly move to the view position or to the origin. The tool bur is always kept in the highest position
along the Z axis and only moves to the specified position along the X and Y axes. You cannot perform this operation during
cutting or while cutting is paused.
WARNING
Procedure
A
Press [MENU] several times to display the following screen.
B
Use the hand-wheel to select the movement destination.
The display differs depending on the selected command set.
R ML m o de
The tool bur moves to the
position whose
N C m o de
Display
View
G54-XY
G55-XY
G56-XY
42
5. Built-in Panel Operation (Practical Use)
This procedure makes the machine operate.
Before you perform this procedure, check to make sure that operation of the machine will
not create any hazard or danger.
mark is lit.
Function
View position
Workpiece coordinate
system origin 1
Workpiece coordinate
system origin 2
Workpiece coordinate
system origin 3
Display Function
View
The spindle head moves to the left edge
and the table moves to the front.
User - XY
Moves the tool bur to the XY origin in
the user coordinate system.
M a c h i n e
Moves the tool bur to the XY origin in the
C o o r d i - machine coordinate system.
nates - XY
Cleaning
The spindle head moves to the right
- XY edge and the table moves to the back.
Rotation A
The rotary axis unit rotates. This can only
be used when the (optional) rotary axis
unit is attached.
A U TO m od e
Display Function
G59-XY
Workpiece coordinate system origin 6
EXOFS-XY Position specified by EXOFS
User Coordi-
User coordinate system origin
nates - XY*
Machine Co- Machine coordinate system origin
ordinates - XY