Emergency Stop or Pause Due to Opening or Closing the Cover
Emergency Stop Due to Opening or Closing the Cover
To ensure safety, opening the front cover or the dust box cover during cutting or spindle rotation causes this machine to
perform an emergency stop. Follow the displayed messages to cancel the emergency stop.
Canceling an Emergency Stop
Procedure
A
When you close the cover, a message is displayed on the built-in panel.
Example)
B
When a screen is displayed asking you to select either "Continue" or "Abort Cutting," select and
then press [ENTER].
The selection screen may not be displayed. In that situation, press [ENTER].
I m p o r t an t
When an emergency stop occurs due to the cover being opened during cutting, selecting "Continue" to
continue cutting may affect the cutting results.
If you want to open the cover during cutting
If you want to open the cover during cutting, press [PAUSE/CANCEL] to pause the cutting, wait for the
operations to stop, and then open the cover. However, when you have disabled the "Tool up in pause"
function in VPanel, the spindle will not pause. Before opening the cover, hold down [SPINDLE] on the built-in
panel to stop the spindle.
" P.51 ""Machine" Tab"
Example)
3. Cutting (One Side Cutting)
13