Automatic Correction Fails; Abnormal Cutting Is Performed; When The Machine Stops With The Tool Bur Inserted In The Workpiece - Roland MDX-50 User Manual

Automatic Correction Fails

Is the detection pin or ATC magazine
dirty?
Is the detection pin properly
attached?

Abnormal Cutting Is Performed

Have the origins been set at correct
positions?
Is the command set correct?

When the Machine Stops with the Tool Bur Inserted in the Workpiece

Procedure
A
Switch off the power.
B
Perform an emergency tool bur release.
1 Switch on the power, and then press [SPINDLE] when the following screen is displayed.
Clean away any grime on the detection pin and the ATC maga-
zine. Fouling due to buildup of cutting waste or the like on this
item may impede correct sensor operation, making detection
impossible.
P. 24 "Step 5 : Setting the Z Origin (Using the Z0 Sensor)"
Verify that the detection pin is properly attached. Check the
position of the tool holder on the detection pin.
"Setup Guide"
Check that the origins have been set correctly. If the origin loca-
tions are not correct, cutting at an unintended location or to the
wrong depth may occur.
P. 22 "Step 4 : Setting the XY Origin"
P. 24 "Step 5 : Setting the Z Origin (Using the Z0 Sensor)"
Check that a command set that is compatible with the application
software you are using has been selected. If the command set is
not compatible, errors may occur, the machine may not operate,
or unintended operations may occur.
P. 51 ""Machine" Tab"
Machine/VPanel Problems
7. Troubleshooting
71