Correcting The Cutting Machine (Automatic Correction) - Roland MDX-50 User Manual

Correcting the Cutting Machine (Automatic Correction)

The accuracy of the cutting machine may change if it is used for a long period of time or the surrounding environment
changes. Performing automatic correction will correct the ATC magazine and rotary axis positions.
Situations Requiring This Work
 When installing the machine
 When replacing the spindle unit
 When the cutting position is misaligned (when an optional rotary axis is connected)
 When a failure occurs during tool bur acquisition or returning
Required Items
Detection pin
1.
Install the detection pin.
A
Clean off any cutting waste around the ATC magazine.
" P. 31 "Cleaning after Cutting Finishes"
B
Use the included cloth for care to wipe clean the detection pin and the protrusions on the left and
right of the ATC magazine.
If any dirt is present in these locations, it may not be possible to perform the correction properly.
C
Load the detection pin in the ATC magazine's number 6 position.
Cloth for care
Part to wipe clean
OK Not OK
Periodic Maintenance
4. Maintenance
35