Step 6 : Outputting Cutting Data - Roland MDX-50 User Manual

Coordinate System in RML-1 Mode
 USER: User coordinate system
Coordinate Systems in NC Code Mode
 G54 : Workpiece coordinate system 1
 G55 : Workpiece coordinate system 2
 G56 : Workpiece coordinate system 3

Step 6 : Outputting Cutting Data

I mp o rt an t
Before starting cutting, check the points listed below. If there are problems with any of these, the machine
may operate unexpectedly,which may waste the workpiece or damage the machine.
• Is the output file correct?
• Is the origin location correct?
• Do the cutting conditions match the type of workpiece?
• Cutting waste and workpieces are flammable.
• Never attempt to cut magnesium or any other such flammable material.
Procedure
A
Check that the front cover and dust box cover are closed.
B
Click .
The VPanel "Cut" dialog box appears.
C
Output the cutting data.
1 Click [Add] to add an output file.
2 Click [Output].
The cutting starts.
M E M O
You can click [Test] to execute the program one line at a time. (Only when the output file is in NC code)
" P.66 ""Cut" Dialog Box"
 G57 : Workpiece coordinate system 4
 G58 : Workpiece coordinate system 5
 G59 : Workpiece coordinate system 6
 EXOFS
3. Cutting (One Side Cutting)
3. Cutting
27