Roland MDX-50 User Manual page 67

Registering Tool Bur Information
If you register the tool bur information in VPanel, you can record the work time of the actually used tool burs and check
the estimated replacement periods. For tool burs used with CAM, you also have to configure the settings on the CAM side.
Procedure
A
Click and then [Cutter registration].
The "Cutter registration" dialog box appears.
B
Register the tool bur.
1 Enter the "Cutter name," "Work time," and "Replacement time."
When registering a new tool bur, enter "0 h 00 m" for the "Work time."
2 Click [Add cutter].
3 Click [Close].
 P. 63 ""Cutter management" Dialog Box"
C
Select a tool bur in the "Cutter management" dialog box.
Click in the VPanel "Cutter management" dialog box to select the tool bur to use. Tool burs that have not been
registered in the "Cutter registration" dialog box are not displayed.
 P. 63 ""Cutter management" Dialog Box"
"Cutter management" Dialog Box
6. VPanel Operation (Practical Use)
65