Detection Points; Addressing - Bosch FPA-5000 System Information Manual

Modular Fire Panel
3.3

Detection Points

Each element or input that can trigger an alarm after programming requires its own detection
point. Detection points are enabled via address cards. One FPA‑5000 manages up to 4096
detection points.
All elements and inputs that do not use the Input type in the Message type setting are
regarded as detection points. Therefore, all elements and inputs for which one of the
following settings is programmed as the Message type are regarded as detection points:
–
–
–
–
–
–
–
–
Only some of these message types are available for selection depending on the element type.
The elements and inputs that can trigger an alarm include all manual and automatic detectors,
as well as the modules and interface modules listed below on the basis of the available inputs.
Modules
CZM 0004 A
IOP 0008 A
ENO 0000 B
Interfaces
FLM-420/4CON
FLM-420-I8R1
FLM-420-I2
FLM-420-O8I2
FLM-420-O1I1
FLM-420-RLE-S
3.4

Addressing

LSN elements are addressed via rotary switches (e.g. FAP 420) or DIP switches (e.g. E/W
versions of the FLM-420).
For the detectors, there are three rotary switches on the underside, which can be used to
select automatic or manual addressing with or without automatic detection.
The following settings are possible:
Rotary switch setting
Bosch Sicherheitssysteme GmbH
Fire
Internal fire
Building control
Multi-criterion
Smoke
Fault
Heat
Water
Detection Points
Up to 4 (1 detection point per zone)
Up to 8 (1 detection point per monitored input)
requires 1 detection point only if a FSE release element is
connected and programmed using the FSP-5000-RPS
programming software
Detection Points
Up to 2
Up to 8
Up to 2
Up to 2
Up to 1
Up to 2
Address
0 0 0
Operating mode
Loop/stub in LSN improved version mode with
automatic addressing (T-tapping not possible) =
factory default setting
System Information
Planning | en 27
09.2017 | 11.3 | F.01U.028.089