Fpp-5000-Ti Trouble Interface; Fpp-5000-Ti13 Communication Interface; Appendix; Options With Requirements Under En 54-2:1997/A1:2006 - Bosch FPA-5000 System Information Manual

Modular Fire Panel
Installation of the power supply unit is described in RMH 0002 A Relay Module for Mains
Voltage, page 117.
7.6.2 FPP‑5000‑TI Trouble Interface
Input voltage
Maximum current consumption
Protection class (IEC 60529)
Addressing
Space required (H x W x D)
The module is described in FPP‑5000 External Power Supply Unit Kit 24 V/6 A, page 121.
7.6.3 FPP‑5000‑TI13 Communication Interface
Input voltage
Current consumption
–
–
Protection class (IEC 60529)
Space required (H x W x D)
The module is described in FPP‑5000 External Power Supply Unit Kit 24 V/6 A, page 121.
8

Appendix

8.1 Options with requirements under EN 54‑2:1997/A1:2006
The FPA-5000 provides the following options with requirements under EN 54‑2:1997/A1:2006:
–
–
–
–
–
–
–
–
–
Bosch Sicherheitssysteme GmbH
From panel rail at 24 V DC
From LSN
Output for activation of fire alarm devices
Activation of fire alarm transmission equipment
– Output to fire alarm transmission equipment
– Alarm acknowledgement input from fire alarm transmission equipment
Output for activation of fire protection equipment
– Output type A
– Output type B
– Output type C
– Fault monitoring of fire protection equipment
Transmission delay
Dependency of fire detection status on more than one alarm signal
– Type A dependency
– Type B dependency
Alarm counter
Fault signal status
– Fault signals from detection points
– Complete failure of power supply
– Output to fault signaling transmission equipment
Disabled status
– Disabling of addressable points
Test status
15 V DC to 30 V DC
1.15 mA (at 24 V), from LSN
IP 20
using eight DIP switches
approx. 127 x 96 x 60 mm
15 V DC to 33 V DC
– 13.2 mA
– 3.25 mA
IP 20
approx. 127 x 96 x 60 mm
System Information
Appendix | en 157
09.2017 | 11.3 | F.01U.028.089