Czm 0004 A 4 Zone Conventional Module; Eno 0000 B Fire Service Interface Module - Bosch FPA-5000 System Information Manual

Modular Fire Panel
4.9.4 CZM 0004 A 4 Zone Conventional Module
The CZM 0004 A Conventional Module enables particular existing conventional peripherals to
be connected. It provides connections for four monitored conventional lines.
Figure 4.58: CZM 0004 A 4 Zone Conventional Module
Labeling
AUX1 + | AUX1 -
OUT1 - | OUT1 +
IN1 - | IN1 +
AUX2 + | AUX2 -
OUT2 - | OUT2 +
IN2 - | IN2 +
AUX3 + | AUX3 -
OUT3 - | OUT3 +
IN3 - | IN3 +
AUX4 + | AUX4 -
OUT4 - | OUT4 +
IN4 - | IN4 +
Notes
–
–
–
Notice!
To ensure that operation of the fire detection system complies with EN 54-13, each
conventional line must be terminated with EOL modules.
The EOL modules can be used with CZM modules from software version 1.1.10 onwards.
The technical data can be found in CZM 0004 A 4 Zone Conventional Module, page 151.
4.9.5 ENO 0000 B Fire Service Interface Module
The ENO 0000 B is used to connect fire service equipment:
Bosch Sicherheitssysteme GmbH
Connection
24 V DC auxiliary power supply zone 1
Zone 1 output low/zone 1 output high
Zone 1 input low/zone 1 input high
24 V DC auxiliary power supply zone 2
Zone 2 output low/zone 2 output high
Class A zone 2 input low/class A zone 2 input high
24 V DC auxiliary power supply zone 3
Zone 3 output low/zone 3 output high
Class A zone 3 input low/class A zone 3 input high
24 V DC auxiliary power supply zone 4
Zone 4 output low/zone 4 output high
Class A zone 4 input low/class A zone 4 input high
All additional voltage outputs (AUX 1-AUX 4) can be switched on and off simultaneously.
Two and four-wire conventional components can be connected.
Note the maximum line resistance:
– 25 Ohm for conventional lines with FMC-300-RW or automatic fire detectors
– 12 Ohm for conventional lines with FMC-120-DKM call points
System Information
Installation | en 107
09.2017 | 11.3 | F.01U.028.089